This document supersedes the October edition of DNV-RP-F The purpose of the revision of this service document is to comply with the new DNV GL. If any person suffers loss or damage which is proved to have been caused by any negligent act or omission of Det Norske Veritas, then Det Norske Veritas shall. DNV-RP-F DESIGN OF DUPLEX STAINLESS STEEL SUBSEA EQUIPMENT EXPOSED TO CATHODIC PROTECTION.
|Published (Last):||23 September 2004|
|PDF File Size:||16.80 Mb|
|ePub File Size:||16.9 Mb|
|Price:||Free* [*Free Regsitration Required]|
Log in to your subscription
Ferritic-austenitic duplex stainless steels DSS are often used to manufacture subsea components for their high strength associated with a good corrosion resistance. Full scale test validation of this approach is limited. Proceedings of an International Conference Submersible Technology: A comprehensive test program is described quantifying the HISC performance of retrieved superduplex stainless steel subsea components and, comparing the actual performance against the limits derived following DNV RP F Ferritic-austenitic duplex and superduplex stainless steels DSSs and SDSSs are an attractive option for subsea equipment and connecting spools, in which the internal corrosion threats can be difficult to manage, using corrosion inhibition and in-line inspection.
In the presence of a critical hydrogen concentration, all duplex and super duplex stainless steels are susceptible to hydrogen embrittlement, via a cracking mechanism commonly referred to as HISC: Proceedings of an international conference Subsea Controls and Data Acquisition ‘ Proceedings of an international conference Oceanology: Log in to your subscription Username.
Hydrogen induced stress cracking using DNV-RP-F – SDEA Solutions
Peer reviewed only Published between: As subsea facilities are protected from seawater corrosion by cathodic protection CPS DSS components are exposed to hydrogen uptake, especially djv a coating system is not in place or has failed at a certain location.
To facilitate this comparison, comprehensive material characterization, small, intermediate and full scale environmental-mechanical testing, and finite element analyses were conducted.
Sheriff’s Encyclopedic Dictionary of Applied Geophysics, fourth edition. ABSTRACT Ferritic-austenitic duplex and superduplex stainless steels DSSs and SDSSs are an attractive option dnc subsea equipment and connecting spools, in which the internal corrosion threats can be difficult to manage, using corrosion inhibition and in-line inspection. Typical uses are short flowlines, welded hubs and flanges, manifolds, towheads, flowbases, sensors and valves.
Instead, the industry assumes that hydrogen charging will happen and relies instead on design approaches that avoid equipment being exposed to stresses or strains exceeding the nominal thresholds for HISC. This CP results in hydrogen charging of the duplex stainless steel, either at uncoated locations ff112, in locations where the coating has lost integrity. Proceedings of an international conference Diverless and Deepwater Techology: Advanced search Show search help.
Whilst ndv such as increased less negative CP potential, tailored microstructure and high-reliability coatings can be considered, these are challenging and are rarely a complete barrier to the threat. Publishers Content Coverage Privacy.